Description
UCOTOP - SPL is a ready to use non-metallic dry shake floor hardener which provides
a highly abrasion and impact resistance dust-free surface to concrete floors which withstand spillages of
Oil Grease and certain industrial chemicals. UCOTOP- SPL is easy to trowel in to the
surface of fresh, wet concrete which cures monolithically to provide a dense, non porous, toughen and hard wearing surface suitable for industrial use.
Properties
- Abrasion Resistance.:
UCOTOP - SPL has been tested as per IS 1237-1980 and found test result shows that
UCOTOP-SPLP improves the abrasion resistance of concrete by 255%
- High compressive strength:
UCOTOP-SPL has a compressive strength of 75 N/MM2 at 28 days
- Light Reflectance
UCOTOP-SPL can reduce the lighting requirement in industrial application and
hence save energy costs in long term.
Where to use
UCOTOP-SPL is suitable for areas subject to constant impact such as quays, foundries,
walkways, machine tool shops, car parks, garages, service stations, machine showrooms, shopping
centres, warehouses, laboratories, abattoirs' bakeries subways, power stations, Engineering workshops etc. |
Technical Data
Form--Gray Powder
Hardness--7 Moh's
Water absolution--6.0 to 6.5%
Method of use
Base Concrete:
The base concrete should have minimum cement content of 300 kg/m3 with water cement ratio being kept to a minimum to produce zero slump.
Particular care should be taken at bay edges.
Dry Shake Method:
UCOTOP - SPL should be applied when the base concrete is sufficiently firm to take the weight of both workman and power float and leaving foot prints
about 3 mm in depth no free water should be evident. Do not delay application when this point is reached.
Broad Casting:
Broad casting UCOTOP - SPL in two equal stages first apply at the rate of 3.5
kg/m2 by sprinkling evenly on to the concrete surface carryout the first power trowel or hand trowel and then repeat the operation but
broadcast the second stage at right angles to the first. Finally when the sheen begins to leave the surface, carry out power trowelling to close the pores and completely level the surface. Do not
over trowel.
Curing:
Curing should be carried out immediately after the final trowelling operation has been completed.
Storage
UCOTOP-SPLP has a shelf life of 12 months if kept in original, unopened packing. Protect from frost and moisture.
Handling Precautions
UCOTOP-SPL is mildly alkaline prolonged contact with skin should be avoided. |