|
Description
UCOGUARD-XL is a ready to use brush applied two pack polymer modified cementitious protective and waterproof coating membrane. Suitable for a
wide range of application. UCOGUARD-XL with its excellent adhesion property to most building materials along with
elastomeric properties proves to be an excellent system for waterproofing of old as well as new structures.
Properties
1. Elastomeric:
UCOGUARD-XL is elastomeric and is unaffected by thermal expansion and contractions caused in structures.
2. Excellent adhesion:
UCOGUARD-XL adheres to most surfaces such as concrete, plasters, bricks, rebars
3. Excellent waterproofing:
UCOGUARD-XL powder consist of waterproofing additive and which penetrate the pores and capillaries of the concrete thereby preventing ingress of water.
UCOGUARD-XL liquid provides an additional barrier and waterproofing coating to the system which will then resist
water under hydrostatic pressure.
Where to use
1.Terrace Water proofing.
2.Damp walls.
3.Dampness around kitchen sinks.
4.Baserments, water tanks, balconies.
5.Retaining walls, bridges.
6.External and internal waterproofing.
7.Reservoirs, coastal structures.
|
Technical Data
Form--Comp A-Liquid Comp B-Powder
Colour--Grey
Density--2000 kg/m3
Mix Ratio--Powder: Liquid 3:1
Pot life--30 mins at 27°c
Bond Strength--7 kg /cm2 (approx)
Method of use
1. Surface
Preparation :
Substrates should be sound, clean and free from any
contaminations like oils, paints, water-repellents, bitumen, release
eggents.
Correct preparation can be achieved by power wire brushing bush or
needle Hammering or high pressure waterjetting.
2. Leaks and Water jets :
Prior to application of UCOGUARD-XL, all leaks and water jets
must be Stopped.
3. Mixing :
The two components are mixed in a clean container with
recommended mix-ratio preferably with paddle mixer to get slurry
consistency mixing is done until the mix is free from lumps and
ensure that a creamy. homogeneous mix is obtained.
4. Application :
The prepared substrate should be thoroughly wetted free from
excess water, then UCOGUARD-XL should be applied in 2 coated at 5-6
ft/kg, by brush application.
5. Curing :
Protect freshly applied surface from direct sunlight and rain
water.
When 1st coat is reasonably hard (4 to 6 hours) apply 2nd coat.
Start curing by sprinkling water for first 24 hours.
Storage Life
UCOGUARD-XL has a shelf of 12 months if unopened in manufacturer's packs in dry
conditions protect from frost.
Coverage
UCOGUARD-XL will provide a coverage of 0-6 sq.ft./kg. at 1-15mm. thickness.
Handling precautions
UCOGUARD-XL is mildly alkaline splashes to the skin should be removed with
clean water.
|